Brocade BigIron RX Series Configuration Guide - Manual (Page 1500)

1422 BigIron RX Series Configuration Guide
53-1002484-04
BGP4
E
always-compare-med “Configuring the device to always compare MEDs” on
page 835
as-path-filter < num> permit | deny < as-path> “Defining an AS-path filter” on page 828
as-path-ignore “Disabling or re-enabling comparison of the AS-path
length”
on page 836
clear ip bgp damping [ < ip-addr> < ip-mask>] “Removing route dampening from a route” on
page 890
“Removing route flap dampening” on page 899
clear ip bgp flap-statistics [regular-expression
< regular-expression> | < address> < mask> | neighbor
< ip-addr>]
“Clearing route flap dampening statistics” on
page 892
“Clearing route flap dampening statistics” on
page 899
clear ip bgp neighbor < ip-addr> [soft in prefix-filter] “Sending and receiving ORFs” on page 885
clear ip bgp neighbor < ip-addr> | < peer-group-name>
soft in
“Placing a policy change into effect” on page 893
clear ip bgp neighbor all | < ip-addr> |
< peer-group-name> | < as-num> [soft-outbound | soft [in
| out]]
“Dynamically refreshing routes” on page 895
clear ip bgp neighbor all | < ip-addr> |
< peer-group-name> | < as-num> traffic
“Clearing traffic counters” on page 898
clear ip bgp neighbor all | < ip-addr> |
< peer-group-name> | < as-num>
last-packet-with-error | notification-errors
“Clearing diagnostic buffers” on page 900
clear ip bgp routes [ < ip-addr>/ < prefix-length>] “Clearing and resetting BGP4 routes in the IP route
table”
on page 898
clear ip bgp traffic “Clearing traffic counters” on page 898
client-to-client-reflection “Disabling or re-enabling client-to-client route
reflection”
on page 836
cluster-id < num> | < ip-addr> “Configuring a route reflector” on page 837
“Configuration procedures” on page 869
community-filter < num> permit | deny < num>: < num> |
internet | local-as | no-advertise | no-export
“Defining a community filter” on page 829
compare-routerid “Enabling or disabling comparison of the router IDs”
on page 837
always-compare-med “Configuring the device to always compare MEDs” on
page 835
confederation identifier < num> “Configuring a BGP confederation” on page 839
confederation peers < num>
[ < num> …]
“Configuring a BGP confederation” on page 839
dampening [ < half-life> < reuse> < suppress>
< max-suppress-time>]
“Configuring route flap dampening” on page 840
default-information-originate “Originating the default route” on page 841
default-local-preference < num> “Changing the default local preference” on page 841
Commands See ...