Brocade BigIron RX Series Configuration Guide - Manual (Page 772)

694 BigIron RX Series Configuration Guide
53-1002484-04
Displaying PIM Sparse configuration information and statistics
24
Displaying the RP set list
To display the RP set list, enter the following command at any CLI level.
Syntax: show ip pim rp-set
This display shows the following information.
Displaying multicast neighbor information
To display information about the BigIron RX’s PIM neighbors, enter the following command at any
CLI level.
This field... Displays...
RP Indicates the IP address of the Rendezvous Point (RP) for the specified
PIM Sparse group.
Following the IP address is the port or virtual interface through which
this BigIron RX learned the identity of the RP.
Info source Indicates the IP address on which the RP information was received.
Following the IP address is the method through which this BigIron RX
learned the identity of the RP.
This field... Displays...
Number of group prefixes The number of PIM Sparse group prefixes for which the RP is
responsible.
Group prefix Indicates the multicast groups for which the RP listed by the previous
field is a candidate RP.
RPs expected/received Indicates how many RPs were expected and received in the latest
Bootstrap message.
RP < num> Indicates the RP number. If there are multiple RPs in the PIM Sparse
domain, a line of information for each of them is listed, and they are
numbered in ascending numerical order.
priority The RP priority of the candidate RP. During the election process, the
candidate RP with the highest priority is elected as the RP.
age The age (in seconds) of this RP-set.
NOTE: If this BigIron RX is not a BSR, this field contains zero. Only the
BSR ages the RP-set.
BigIron RX(config)#show ip pim rp-set
Group address Static-RP-address Override
---------------------------------------------------
Access-List 44 99.99.99.5 On
Number of group prefixes Learnt from BSR: 1
Group prefix = 239.255.162.0/24 # RPs expected: 1
# RPs received: 1
RP 1: 43.43.43.1 priority=0 age=0