Brocade BigIron RX Series Configuration Guide - Manual (Page 1056)

978 BigIron RX Series Configuration Guide
53-1002484-04
Displaying IPv4 IS-IS information
29
Displaying traffic statistics
The device maintains statistics for common IS-IS PDU types. To display the statistics, use either of
the following methods.
To display IS-IS PDU statistics, enter the following command at any level of the CLI.
Syntax: show isis traffic
This display shows the following information.
IP address The IP address of the interface that sent the LSP. The device can use
this address as the next hop in routes to the addresses listed in the rows
below.
Destination addresses The rows of information below the IP address row are the destinations
advertised by the LSP. The device can reach these destinations by using
the IP address listed above as the next hop.
Each destination entry contains the following information:
•
Metric – The value of the default metric, which is the IS-IS cost of
using the IP address above as the next hop to reach this
destination.
•
Device type – The device type at the destination. The type can be
one of the following:
• End System – The device is an ES.
• IP-Internal – The device is an ES within the current area.
The IP address and subnet mask are listed.
• IS – The device is another IS. The NET (NSAP address) is
listed.
• IP-Extended – Same as IP-Internal, except the device
uses the extended TLV fields described in
draft-ietf-isis-traffic-02.txt to carry the information.
• IS-Extended – Same as IS, except the device uses the
extended TLV fields described in
draft-ietf-isis-traffic-02.txt to carry the information.
TABLE 152 IS-IS detailed LSP database information (Continued)
This field... Displays...
BigIron RX# show isis traffic
Message Received Message Sent
Level-1 Hellos 1029 115
Level-2 Hellos 1027 112
Level-1 LSP 6 3
Level-2 LSP 6 3
Level-1 CSNP 0 0
Level-2 CSNP 0 0
Level-1 PSNP 107 0
Level-2 PSNP 107 0