Displaying ip interface information – Brocade BigIron RX Series Configuration Guide User Manual
Page 302
224
BigIron RX Series Configuration Guide
53-1002484-04
Displaying IP information
7
Displaying IP interface information
To display IP interface information, enter the following command at any CLI level.
Syntax: show ip interface [ethernet <slot/port>] | [loopback <num>] | [ve <num>]
This display shows the following information.
Subnet Mask
The network mask for the IP address.
Next Hop Router
The IP address of the router interface to which the Brocade router sends
packets for the route.
Metric
The cost of the route. Usually, the metric represents the number of hops to
the destination.
Distance
The administrative distance of the route. The default administrative distance
for static IP routes in Brocade routers is 1.
To list the default administrative distances for all types of routes or to
change the administrative distance of a static route, refer to
Policies
Index
The policy number. This is the number you assigned the policy when you
configured it.
Action
The action the router takes if a packet matches the comparison values in
the policy. The action can be one of the following:
•
deny – The router drops packets that match this policy.
•
permit – The router forwards packets that match this policy.
Source
The source IP address the policy matches.
Destination
The destination IP address the policy matches.
Protocol
The IP protocol the policy matches. The protocol can be one of the following:
•
ICMP
•
IGMP
•
IGRP
•
OSPF
•
TCP
•
UDP
Port
The Layer 4 TCP or UDP port the policy checks for in packets. The port can
be displayed by its number or, for port types the router recognizes, by the
well-known name. For example, TCP port 80 can be displayed as HTTP.
NOTE: This field applies only if the IP protocol is TCP or UDP.
Operator
The comparison operator for TCP or UDP port names or numbers.
NOTE: This field applies only if the IP protocol is TCP or UDP.
TABLE 54
CLI display of global IP configuration information (Continued)
This field...
Displays...
BigIron RX(config)# show ip interface
Interface IP-Address OK? Method Status Protocol
Ethernet 1/1 207.95.6.173 YES NVRAM up up
Ethernet 1/2 3.3.3.3 YES manual up up
Loopback 1 1.2.3.4 YES NVRAM down down