Route map level, Router vrrp level, Router vrrpe level – Brocade BigIron RX Series Configuration Guide User Manual

Page 84: Vlan level, Metro ring level, Vsrp level, Topology group level, 1x port security level

BigIron RX Series Configuration Guide

53-1002484-04

CONFIG commands

Route Map level

The Route Map level allows you to configure parameters for a BGP4 route map. You reach this level
by entering the route-map <name> command at the global CONFIG level.

Router VRRP level

The VRRP level allows you to configure parameters for the Virtual Router Redundancy Protocol
(VRRP). You reach this level by entering the router vrrp command at the global CONFIG level, then
entering the ip vrrp vrid command at the interface configuration level.

Router VRRPE level

The VRRPE level allows you to configure parameters for VRRP Extended. You reach this level by
entering the router vrrp-extended command at the global CONFIG level, then entering the ip
vrrp-extended vrid command at the interface configuration level.

VLAN level

Policy-based VLANs allow you to assign VLANs to a protocol, port, or 802.1q tags.

You reach this level by entering the vlan <vlan-id> command at the Global CONFIG Level.

Metro ring level

Metro rings provide Layer 2 connectivity and fast failover in ring topologies.

You reach this level by entering the metro-ring command at the Global CONFIG Level.

VSRP level

The VSRP level allows you to configure parameters for the Virtual Switch Redundancy Protocol
(VSRP). You reach this level by entering the vsrp vrid <num> command at the VLAN configuration
level, then entering the vsrp vrid <num> command at the VLAN configuration level.

Topology group level

A topology group enables you to control the Layer 2 protocol configuration and Layer 2 state of a set
of ports in multiple VLANs based on the configuration and states of those ports in a single master
VLAN. One instance of the Layer 2 protocol controls all the VLANs.

You reach this level by entering the topology-group <group-id> command at the Global CONFIG
Level.

802.1x port security level

The 802.1x port security level allows you to configure the 802.1x port security. You reach this level
by entering the dot1x-enable command at the at the Global level.