Brocade BigIron RX Series Configuration Guide - Manual (Page 1471)

BigIron RX Series Configuration Guide 1393
53-1002484-04
Syslog messages
A
Notification Module was inserted to slot < slot-num> Indicates that a module was inserted into a
device slot.
The
< slot-num> is the number of the device
slot into which the module was inserted.
Notification Module was removed from slot < slot-num> Indicates that a module was removed from a
device slot.
The
< slot-num> is the number of the device
slot from which the module was removed.
Notification ACL insufficient L4 session resource, using
flow based ACL instead The device does not have enough Layer 4
session entries.
To correct this condition, allocate more
memory for sessions. To allocate more
memory, enter the following command at the
global CONFIG level of the CLI interface.
system-max session-limit
< num>
Notification ACL exceed max DMA L4 cam resource, using
flow based ACL instead The port does not have enough Layer 4 CAM
entries for the ACL.
To correct this condition, allocate more Layer
4 CAM entries. To allocate more Layer 4 CAM
entries, enter the following command at the
CLI configuration level for the interface.
ip access-group max-l4-cam
< num>
Notification ACL insufficient L4 cam resource, using flow
based ACL instead The port does not have a large enough CAM
partition for the ACLs.
Notification ACL system fragment packet inspect rate
< rate> exceeded
The fragment rate allowed on the device has
been exceeded.
The
< rate> indicates the maximum rate
allowed.
This message can occur if fragment thottling
is enabled.
Notification ACL port fragment packet inspect rate < rate>
exceeded on port < portnum>
The fragment rate allowed on an individual
interface has been exceeded.
The
< rate> indicates the maximum rate
allowed.
The
< portnum> indicates the port.
This message can occur if fragment thottling
is enabled.
TABLE 242 Brocade Syslog messages (Continued)
Message level Message Explanation