Brocade BigIron RX Series Configuration Guide - Manual (Page 82)

4 BigIron RX Series Configuration Guide
53-1002484-04
CONFIG commands
1
You reach this level by entering the enable [] or enable at
the User EXEC level.
BigIron RX>enable
or
BigIron RX>enable user1 mypassword
After entering the enable command, you see the following prompt.
BigIron RX>#.
The prompt indicates that you are at the Privilege EXEC level.
When you are at the Privilege EXEC level, you can enter commands that are available at that level.
It is also at this level where you enter the configure terminal command to Global Configuration
level.
Global level
The global CONFIG level allows you to globally apply or modify parameters for ports on the device.
You reach this level by entering configure terminal at the privileged EXEC level.
BigIron RX>enable
BigIron RX>#configuration terminal
The prompt changes to the Global Configuration level.
BigIron RX(config)#
CONFIG commands
CONFIG commands modify the configuration of a device. Once you are at the Global Configuration
level, you can enter commands to configure the features in the device. This section describes the
following CONFIG CLI levels.
Redundancy level
This redundancy level allows you to configure redundancy parameters for redundant management
modules. You reach this level by entering the redundancy command at the global CONFIG level.
Interface level
The interface level allows you to assign or modify specific port parameters on a port-by-port basis.
You reach this level by entering the following at the global CONFIG level:
• interface ethernet <slot/port>
• interface loopback <num>
• interface management <portnum>
• interface ve <num>
• interface tunnel <tunnel_id>