Brocade BigIron RX Series Configuration Guide - Manual (Page 1442)

1364 BigIron RX Series Configuration Guide
53-1002484-04
Multicast Listener Discovery and source specific multicast protocols (MLDv2)
50
Displaying MLD definitions for an interface
To display the MLD parameters on an interface, including the various timers, the current querying
router, and whether or not MLD is enabled, enter the following command.
Syntax: show ipv6 mld interface [<port-number>]
Enter the port’s number if you want to display MLD information for a specific interface.
Displaying MLD traffic
To display information on MLD traffic, enter a command such as the following.
This field... Displays...
version Version of the MLD being used.
query int Query interval in seconds.
max resp time Number of seconds multicast groups have to respond to queries.
group mem time Number of seconds multicast groups can be members of this group before aging
out.
(details) The following is displayed for each interface:
•
The port ID
•
The default MLD version being used
•
The multicast protocol used
•
IPV6 address of the multicast interface
•
If the interface has groups, the group source list, IPv6 multicast address, and
the filter mode are displayed.
BigIron RX #show ipv6 mld interface
version = 2, query int = 125, max resp time = 10, group mem time = 635
robustness = 5, other querier present time = 630
last listener query int = 1, last listener query count = 5
e5/18: default V2, PIM sparse, addr=fe80::20c:dbff:fe80:5251
has 50 groups, Querier, default V2
group: ff1e::619, exclude, permit 0, exclude-time=513, deny 0
group: ff1e::618, exclude, permit 0, exclude-time=513, deny 0
group: ff1e::617, exclude, permit 0, exclude-time=513, deny 0
group: ff1e::616, exclude, permit 0, exclude-time=513, deny 0
group: ff1e::5a8, exclude, permit 0, exclude-time=513, deny 0
group: ff1e::5a7, exclude, permit 0, exclude-time=513, deny 0
group: ff1e::5a6, exclude, permit 0, exclude-time=513, deny 0