beautypg.com

Displaying mbgp routes – Brocade BigIron RX Series Configuration Guide User Manual

Page 1020

background image

942

BigIron RX Series Configuration Guide

53-1002484-04

Displaying MBGP information

28

This example shows how to display information for a specific neighbor, by specifying the neighbor’s
IP address with the command. The number in the far left column indicates the neighbor for which
information is displayed. When you list information for multiple neighbors, this number makes the
display easier to read.

The Neighbor NLRI Negotiation section (shown in bold type) lists the types of routes that this device
can exchange with the MBGP neighbor.

The TCP statistics at the end of the display show status for the TCP session with the neighbor. Most
of the fields show information stored in the device’s Transmission Control Block (TCB) for the TCP
session between the device and its neighbor. These fields are described in detail in section 3.2 of
RFC 793, “Transmission Control Protocol Functional Specification”.

Syntax: show ip mbgp neighbors [<ip-addr>]

The <ip-addr> parameter specifies the neighbor’s IP address.

Displaying MBGP routes

To display the MBGP route table, enter the following command.

BigIron RX # show ip mbgp neighbor 7.7.7.2

Total number of BGP Neighbors: 1

1 IP Address: 166.1.1.2, Remote AS: 200 (IBGP), RouterID: 8.8.8.1

State: ESTABLISHED, Time: 0h33m26s, KeepAliveTime: 60, HoldTime: 180

KeepAliveTimer Expire in 9 seconds, HoldTimer Expire in 161 seconds

PeerGroup: mbgp-mesh

MD5 Password: $Gsig@U\

NextHopSelf: yes

RefreshCapability: Received

Messages: Open Update KeepAlive Notification Refresh-Req

Sent : 2 3264 17 0 0

Received: 1 1 34 0 0

Last Update Time: NLRI Withdraw NLRI Withdraw

Tx: --- --- Rx: --- ---

Last Connection Reset Reason:Unknown

Notification Sent: Unspecified

Notification Received: Unspecified

Neighbor NLRI Negotiation:

Peer Negotiated IPV4 multicast capability

Peer configured for IPV4 multicast Routes

TCP Connection state: ESTABLISHED, MD5-Password: ********

TTL check: 0, value: 0, rcvd: 64

Byte Sent: 284418, Received: 767

Local host: 166.1.1.1, Local Port: 179

Remote host: 166.1.1.2, Remote Port: 8137

ISentSeq: 2763573 SendNext: 3047992 TotUnAck: 0

TotSent: 284419 ReTrans: 0 UnAckSeq: 3047992

IRcvSeq: 3433336 RcvNext: 3434104 SendWnd: 65000

TotalRcv: 768 DupliRcv: 0 RcvWnd: 65000

SendQue: 0 RcvQue: 0 CngstWnd: 1440