Port parameters – Brocade BigIron RX Series Configuration Guide User Manual
Page 1527
BigIron RX Series Configuration Guide
1449
53-1002484-04
Port parameters
E
Port parameters
show ip ospf virtual neighbor [
<
num>]
“Displaying OSPF virtual neighbor and link
information”
show tasks
“Displaying CPU utilization and other OSPF tasks”
snmp-server trap ospf
<
ospf-trap>
“Modifying OSPF traps generated”
summary-address
<
ip-addr>
<
ip-mask>
“Configure external route summarization”
timers lsa-group-pacing
<
secs>
“Changing the LSA pacing interval”
timers spf
<
delay>
<
hold-time>
Commands
See ...
Commands
See ...
config-trunk-ind
“Mirror ports for Policy-Based Routing (PBR) traffic”
disable
“Disabling or re-enabling a port”
enable
“Disabling or re-enabling a port”
flow-control
“Disabling or re-enabling flow control”
gig-default neg-full-auto | auto-gig | neg-off
“Changing the default Gigabit negotiation mode”
“Changing the default Gigabit negotiation mode”
ip address
<
ip-addr>
<
ip-mask> |
<
ip-addr>/
<
mask-bits>
“Assigning an IP address to a port”
lock-address ethernet
<
portnum> [addr-count
<
num>]
monitor
ethe-port-monitored
<
portnum> | named-port-monitored
<
portname> ethernet |
<
portnum>
in | out | both
“Mirror ports for Policy-Based Routing (PBR) traffic”
phy-mode wan
“Enabling WAN PHY mode support”
port-name
<
text>
qd-flow sink
<
sinking-threshold> sunk
<
sunk-threshold>
slot
<
slot>
“Specifying threshold values for flow control”
set mirror-interface
<
slot number>/
<
port number>
“Configuring mirror ports for PBR traffic”
show monitor actual
“Displaying mirror and monitor port configuration”
show monitor config
“Displaying mirror and monitor port configuration”
speed-duplex
<
value>