Brocade BigIron RX Series Configuration Guide - Manual (Page 1503)

BigIron RX Series Configuration Guide 1425
53-1002484-04
BGP4
E
next-hop-enable-default “Using the IP default route as a valid next hop for a
BGP4 route”
on page 858
next-hop-recursion “Enabling recursive next-hop lookups” on page 861
redistribute connected [metric < num>] [route-map
< map-name>]
“Redistributing connected routes” on page 862
redistribute connected | ospf | rip | isis | static “Using the IP default route as a valid next hop for a
BGP4 route”
on page 858
redistribute isis level-1 | level-1-2 | level-2 [metric
< num>] [route-map < map-name>]
“Redistributing ISIS” on page 863
redistribute ospf [match internal | external1 | external2]
[metric
< num>] [route-map < map-name>]
“Redistributing OSPF external routes” on page 863
redistribute rip [metric < num>] [route-map < map-name>] “Redistributing RIP routes” on page 862
redistribute static [metric < num>] [route-map
< map-name>]
“Redistributing static routes” on page 864
route-map < map-name> permit | deny < num> “Entering the route map Into the software” on
page 877
set
[as-path [prepend
< as-num,as-num,...>]] |
[automatic-tag] |
[comm-list
< acl> delete] |
[community < num>: < num> | < num> | internet | local-as
| no-advertise | no-export] |
[dampening [
< half-life> < reuse> < suppress>
< max-suppress-time>]]
[ip next hop < ip-addr>]
[ip next-hop peer-address] |
[local-preference
< num>] |
[metric [+ | - ] < num> | none] |
[metric-type type-1 | type-2] | external
[metric-type internal] |
[next-hop
< ip-addr>] |
[origin igp | incomplete] |
[tag
< tag-value>] |
[weight < num>]
“Setting parameters in the routes” on page 881
set comm-list < acl> delete “Deleting a community from a BGP4 route” on
page 884
set ip next-hop peer-address “Setting the next hop of a BGP4 route” on page 883
set metric-type internal “Setting a BP4 route’s MED to be equal to the
next-hop route IGP metric”
on page 883
show ip bgp [route] < ip-addr>/ < prefix> [longer-prefixes] |
< ip-addr>
“Displaying information for a specific route” on
page 920
show ip bgp attribute-entries “Displaying BGP4 route-attribute entries” on
page 924
show ip bgp config “Displaying the active BGP4 configuration” on
page 903
show ip bgp filtered-routes [ < ip-addr>] |
[as-path-access-list < num>] | [detail] | [prefix-list
< string>]
“Displaying the filtered routes received from the
neighbor or peer group”
on page 894
Commands See ...