Brocade BigIron RX Series Configuration Guide - Manual (Page 253)

BigIron RX Series Configuration Guide 175
53-1002484-04
Configuring IP parameters
7
The <number> parameter indicates the tunnel interface number for which you want to display
information.
This display shows the following information.
Displaying interface level IPv6 settings
To display Interface level IPv6 settings for tunnel interface 1, enter the following command at any
level of the CLI.
BigIron RX#show ipv6 inter tunnel 1
Interface Tunnel 1 is up, line protocol is up
IPv6 is enabled, link-local address is fe80::3:4:2 [Preferred]
Global unicast address(es):
1001::1 [Preferred], subnet is 1001::/64
1011::1 [Preferred], subnet is 1011::/64
Joined group address(es):
ff02::1:ff04:2
ff02::5
ff02::1:ff00:1
ff02::2
ff02::1
MTU is 1480 bytes
ICMP redirects are enabled
No Inbound Access List Set
No Outbound Access List Set
OSPF enabled
The display command above reflects the following configuration.
BigIron RX#show running-config interface tunnel 1
TABLE 50 IPv6 tunnel interface information
This field... Displays...
Tunnel interface status The status of the tunnel interface can be one of the following:
•
up – The tunnel interface is functioning properly.
•
down – The tunnel interface is not functioning and is down.
Line protocol status The status of the line protocol can be one of the following:
•
up – The line protocol is functioning properly.
•
down – The line protocol is not functioning and is down.
Hardware is tunnel The interface is a tunnel interface.
Tunnel source The tunnel source can be one of the following:
•
An IPv4 address
•
The IPv4 address associated with an interface or port.
Tunnel destination The tunnel destination can an IPv4 address.
Tunnel mode The tunnel mode can be one the following:
•
ipv6ip auto-tunnel – Indicates an automatic IPv4-compatible tunnel.
•
ipv6ip 6to4 – Indicates an automatic 6to4 tunnel.
Port name The port name configured for the tunnel interface.
MTU The setting of the IPv6 maximum transmission unit (MTU).