Brocade BigIron RX Series Configuration Guide - Manual (Page 626)

548 BigIron RX Series Configuration Guide
53-1002484-04
Configuring MCT
20
------------
Name Rbridge-id Config Port Trunk FSM-State
Client1 2222 Deployed 1/2 3 Up
Client2 222 Deployed 1/40 - Up
Syntax: show cluster [<name> | <client-id>]
The <name> variable specifies the cluster name.
The <client-id> variable specifies the client ID.
Displaying cluster client reachability information
To display cluster client reachability information, enter a command such as the following.
BigIron RX# show cluster abc client c1
Cluster abc 1
=============
Rbridge Id: 100, Session Vlan: 4090
Cluster State: Deploy
Clients State: All client ports are administratively disabled [Optional]
Client Isolation Mode: Strict [Optional]
Configured Member Vlan Range: 20 to 30
Active Member Vlan Range: 20
Client Info:
------------
Client: c1, rbridge-id: 300, Deployed
Client Port: 1/13
State: Up
Syntax: show cluster <name> client <client-rbridge>
The <name> variable specifies the name of the cluster.
The <client-rbridge> variable specifies the RBridge ID of the client.
Displaying cluster peer state information
To display cluster peer state information, enter a command such as the following.
BigIron RX# show cluster abc peer 10.10.10.1
Cluster abc 1
=============
Rbridge Id: 100, Session Vlan: 4090
Cluster State: Deploy
Clients State: All client ports are administratively disabled [Optional]
Client Isolation Mode: Strict [Optional]
Configured Member Vlan Range: 20 to 30
Active Member Vlan Range: 20
Peer Info:
----------
Peer IP: 10.10.10.2, Peer Rbridge Id: 200, ICL: icl1
KeepAlive Interval: 20 , Hold Time: 60, Fast Failover
Active Vlan Range: 20
Peer State: CCP Up (Up Time: 0 days: 1 hr:51 min:21 sec)
Syntax: show cluster [<name> | <id>] peer <peer-ip>