Brocade BigIron RX Series Configuration Guide - Manual (Page 1411)

BigIron RX Series Configuration Guide 1333
53-1002484-04
Displaying OSPFv3 information
49
Syntax: show ipv6 ospf redistribute route [<ipv6-prefix>]
The <ipv6-prefix> parameter specifies an IPv6 network prefix. (You do not need to specify the
length of the prefix.)
For example, to display redistribution information for the prefix 2002::, enter the following
command at any level of the CLI.
These displays show the following information.
Displaying OSPFv3 route information
You can display the entire OSPFv3 route table for the Brocade device or only the route entries for a
specified destination.
To display the entire OSPFv3 route table for the device, enter the following command at any level of
the CLI.
TABLE 233 OSPFv3 redistribution information
This Field... Displays...
ID An ID for the redistributed route.
Prefix The IPv6 routes redistributed into OSPFv3.
Protocol The protocol from which the route is redistributed into OSPFv3. Redistributed
protocols can be the following:
•
BGP – BGP4+.
•
RIP – RIPng.
•
ISIS – IPv6 IS-IS.
•
Static – IPv6 static route table.
•
Connected – A directly connected network.
Metric Type The metric type used for routes redistributed into OSPFv3. The metric type can
be the following:
•
Type-1 – Specifies a small metric (2 bytes).
•
Type-2 – Specifies a big metric (3 bytes).
Metric The value of the default redistribution metric, which is the OSPF cost of
redistributing the route into OSPFv3.
BigIron RX# show ipv6 ospf redistribute route
Id Prefix Protocol Metric Type Metric
snIpAsPathAccessListStringRegExpression
1 2002::/16 Static Type-2 1
2 2002:1234::/32 Static Type-2 1
BigIron RX# show ipv6 ospf redistribute route 2002::
Id Prefix Protocol Metric Type Metric
1 2002::/16 Static Type-2 1