Brocade BigIron RX Series Configuration Guide - Manual (Page 568)

490 BigIron RX Series Configuration Guide
53-1002484-04
Displaying QoS configuration information
18
The <prio0> through <prio7> parameters specify the COS values you are mapping the eight
internal priorities to. You must enter CoS values for all eight internal priorities, in order from priority
0 – 7.
Displaying QoS configuration information
To display configuration information, enter the following command at any level of the CLI.
Syntax: show qos-tos
This command shows the following information.
BigIron RX# show qos-tos
Interface QoS , Marking and Trust Level:
i/f | QoS | Mark | Trust-Level
-------+-----+----------+---------------
1/2 | Yes | | Layer 2 CoS
ve1 | No | | Layer 2 CoS
ve4 | No | | Layer 2 CoS
ve5 | No | | Layer 2 CoS
ve20 | No | | Layer 2 CoS
COS-DSCP map:
COS: 0 1 2 3 4 5 6 7
-------------------------------------------------
dscp: 0 8 16 24 32 40 48 56
DSCP-Priority map: (dscp = d1d2)
d2 | 0 1 2 3 4 5 6 7 8 9
d1 |
-----+----------------------------------------
0 | 0 0 0 0 0 0 0 0 1 1
1 | 1 1 1 1 1 1 2 2 2 2
2 | 2 2 2 2 3 3 3 3 3 3
3 | 3 3 4 4 4 4 4 4 4 4
4 | 5 5 5 5 5 5 5 5 6 6
5 | 6 6 6 6 6 6 7 7 7 7
6 | 7 7 7 7
DSCP-DSCP map: (dscp = d1d2)
d2 | 0 1 2 3 4 5 6 7 8 9
d1 |
-----+----------------------------------------
0 | 0 1 2 3 4 5 6 7 8 9
1 | 10 11 12 13 14 15 16 17 18 19
2 | 20 21 22 23 24 25 26 27 28 29
3 | 30 31 32 33 34 35 36 37 38 39
4 | 40 41 42 43 44 45 46 47 48 49
5 | 50 51 52 53 54 55 56 57 58 59
6 | 60 61 62 63
COS-Priority map:
COS: 0 1 2 3 4 5 6 7
------------------------------------------------
Priority: 0 1 2 3 4 5 6 7