Brocade BigIron RX Series Configuration Guide - Manual (Page 900)

822 BigIron RX Series Configuration Guide
53-1002484-04
Configuring BGP4
27
default-local-preference x “Changing the default local preference” on
page 841
default-metric x x “Changing the default metric used for
redistribution”
on page 842
distance x “Changing administrative distances” on
page 842
enforce-first-as x “Requiring the first AS to be the neighbor’s
AS”
on page 843
exit-address-family x x x “Entering and exiting the address family
configuration level”
on page 826
fast-external-fallover x “Enabling fast external fallover” on page 844
local-as x “Setting the local AS number” on page 845
maximum-paths x “Changing the maximum number of shared
BGP4 paths”
on page 845
med-missing-as-worst x “Treating missing MEDs as the worst MEDs”
on page 845
multipath x “Customizing BGP4 load sharing” on
page 846
neighbor x x x “Configuring BGP4 neighbors” on page 846
“Configuring a BGP4 peer group” on
page 854
network x x “Specifying a list of networks to advertise” on
page 857
next-hop-enable-default x “Using the IP default route as a valid next hop
for a BGP4 route”
on page 858
next-hop-recursion x “Enabling next-hop recursion” on page 858
redistribute x x “Modifying redistribution parameters” on
page 861
show x x x “Displaying BGP4 information” on page 900
table-map x x “Using a table map to set the tag value” on
page 864
timers x “Changing the keep alive time and hold time”
on page 865
update-time x x “Changing the BGP4 next-hop update timer”
on page 865
TABLE 132 IPv4 BGP commands at different configuration levels (Continued)
Command Global
(iPv4 and
IPv6) IPv4 address
family unicast IPv4 address
family
multicast See