Brocade BigIron RX Series Configuration Guide - Manual (Page 1495)

BigIron RX Series Configuration Guide 1417
53-1002484-04
Appendix
D
Commands That Require a Reload
Most CLI commands take effect as soon as you enter them. However, a small number of
commands require a software reload to take effect.
Table 245 lists the commands.
To place a configuration change made by one of these commands into effect, you must save the
change to the startup-config file, then reload the software. If you reload the software without
saving the change to the startup-config file, the device does not make the change.
To reload the software, you must perform a cold start. To perform a cold start, do one of the
following:
• Enter the reload command at the Privileged EXEC level of the CLI.
• Cycle the power by powering down the device, then powering it on again.
NOTE
The boot system command does not perform a cold start. It performs a warm start.
TABLE 245 Commands that require a software reload
Command See ...
max-frame-size “Setting maximum frame size per PPCR” on page 182
system-max “Displaying and modifying system parameter default settings” on
page 133