Brocade BigIron RX Series Configuration Guide - Manual (Page 1482)

1404 BigIron RX Series Configuration Guide
53-1002484-04
Syslog messages
A
Notification Local TCP exceeds < num> burst packets,
stopping for < num> seconds!!
Threshold parameters for local TCP traffic on
the device have been configured, and the
maximum burst size for TCP packets has
been exceeded.
The first
< num> is the maximum burst size
(maximum number of packets allowed).
The second
< num> is the number of seconds
during which additional TCP packets will be
blocked on the device.
Note: This message can occur in response to
an attempted TCP SYN attack.
Notification Transit TCP in interface < portnum> exceeds
< num> burst packets, stopping for < num>
seconds!!
Threshold parameters for TCP transit
(through) traffic have been configured on an
interface, and the maximum burst size for
TCP packets on the interface has been
exceeded.
The
< portnum> is the port number.
The first < num> is the maximum burst size
(maximum number of packets allowed).
The second
< num> is the number of seconds
during which additional TCP packets will be
blocked on the interface.
Note: This message can occur in response to
an attempted TCP SYN attack.
Notification ISIS L1 ADJACENCY DOWN < system-id> on
circuit < circuit-id>
The device’s adjacency with this Level-1 IS
has gone down.
The
< system-id> is the system ID of the IS.
The < circuit-id> is the ID of the circuit over
which the adjacency was established.
Notification ISIS L1 ADJACENCY UP < system-id> on
circuit < circuit-id>
The device’s adjacency with this Level-1 IS
has come up.
The
< system-id> is the system ID of the IS.
The < circuit-id> is the ID of the circuit over
which the adjacency was established.
Notification ISIS L2 ADJACENCY DOWN < system-id> on
circuit < circuit-id>
The device’s adjacency with this Level-2 IS
has gone down.
The
< system-id> is the system ID of the IS.
The < circuit-id> is the ID of the circuit over
which the adjacency was established.
Notification ISIS L2 ADJACENCY UP < system-id> on
circuit < circuit-id>
The device’s adjacency with this Level-2 IS
has come up.
The
< system-id> is the system ID of the IS.
The < circuit-id> is the ID of the circuit over
which the adjacency was established.
Notification ISIS ENTERED INTO OVERLOAD STATE The device has set the overload bit to on (1),
indicating that the device’s IS-IS resources
are overloaded.
Notification ISIS EXITING FROM OVERLOAD STATE The device has set the overload bit to off (0),
indicating that the device’s IS-IS resources
are no longer overloaded.
TABLE 242 Brocade Syslog messages (Continued)
Message level Message Explanation