Brocade BigIron RX Series Configuration Guide - Manual (Page 72)

lxxii BigIron RX Series Configuration Guide
53-1002484-04
Layer 2 enhancements
Layer 3 enhancements
TABLE 23 Layer 2 enhancements
Enhancement Description See page
VLAN Byte Accounting With this release, you can configure a VLAN to account
for the number of bytes received by all the member
ports. Book: BigIron RX Series
Configuration Guide
Chapter:
“VLANs”
Section: “VLAN byte
accounting”
Super Aggregated VLANs
(SAV) Multiple VLANs can be aggregated within another VLAN
to allow you to construct Layer 2 paths and channels. Book: BigIron RX Series
Configuration Guide
Chapter:
“VLANs”
Section: “Configuring
super aggregated VLANs”
Enhancement to the lacp
system-priority command The lacp system-priority command has been moved
from the interface configuration level to the global
configuration level. Book: BigIron RX Series
Configuration Guide
Chapter: See the
Dynamic Link
Aggregation chapter in
the BigIron RX Series
Configuration Guide -
Versions 02.5.00 and
earlier.
Section:Configuring Link
Aggregation Parameters
TABLE 24 Layer 3 enhancements
Enhancement Description See page
Graceful Restart With this release, you can enable Graceful Restart
for OSPF and BGP Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring
OSPF Version 2 (IPv4)”
and “Configuring BGP4
(IPv4 and IPv6)”
Section: “OSPF graceful
restart” and “Graceful
restart in BGP”
BGP Null0 Routing With this release, BGP can use null0 to resolve the
next hop and install null0 BGP routes to the routing
table Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring
BGP4 (IPv4 and IPv6)”
Section: “BGP Null0
routing”
GRE IP Tunneling This release supports creation of a GRE tunnel
across an IP network. Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring IP”
Section: “GRE IP tunnel”