Brocade BigIron RX Series Configuration Guide - Manual (Page 1190)

1112 BigIron RX Series Configuration Guide
53-1002484-04
Reading CDP packets
38
Displaying CDP entries
To display CDP entries for all neighbors, enter the following command.
Syntax: show fdp entry * | <device-id>
To display CDP entries for a specific device, specify the device ID. Here is an example.
Displaying CDP statistics
To display CDP packet statistics, enter the following command.
BigIron RX# show fdp traffic
CDP counters:
Total packets output: 0, Input: 3
Hdr syntax: 0, Chksum error: 0, Encaps failed: 0
No memory: 0, Invalid packet: 0, Fragmented: 0
Syntax: show fdp traffic
Clearing CDP information
You can clear the following CDP information:
• Cisco Neighbor information
• CDP statistics
To clear the Cisco neighbor information, enter the following command.
BigIron RX# show fdp entry *
Device ID: Router
Entry address(es):
IP address: 207.95.6.143
Platform: cisco RSP4, Capabilities: Router
Interface: Eth 1/1, Port ID (outgoing port): FastEthernet5/0/0
Holdtime : 124 seconds
Version :
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-JSV-M), Version 12.0(5)T1, RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Thu 19-Aug-99 04:12 by cmong
BigIron RX# show fdp entry Router1
Device ID: Router1
Entry address(es):
IP address: 207.95.6.143
Platform: cisco RSP4, Capabilities: Router
Interface: Eth 1/1, Port ID (outgoing port): FastEthernet5/0/0
Holdtime : 156 seconds
Version :
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-JSV-M), Version 12.0(5)T1, RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Thu 19-Aug-99 04:12 by cmong