Brocade BigIron RX Series Configuration Guide - Manual (Page 1312)

1234 BigIron RX Series Configuration Guide
53-1002484-04
Displaying BGP4+ information
46
This display shows the following information.
TABLE 201 Summary of BGP4+ routes
This field... Displays...
Number of BGP4+ Routes The number of routes displayed by the command.
Status codes A list of the characters the display uses to indicate the route’s status.
The status code appears in the Status column of the display. The status
codes are described in the command’s output.
Prefix The route’s prefix.
Next Hop The next-hop switch for reaching the route from the switch.
Metric The value of the route’s MED attribute. If the route does not have a
metric, this field is blank.
LocPrf The degree of preference for the advertised route relative to other routes
in the local AS. When the BGP4+ algorithm compares routes on the
basis of local preferences, the route with the higher local preference is
chosen. The preference can have a value from 0 – 4294967295.
Weight The value that this switch associates with routes from a specific
neighbor. For example, if the switch receives routes to the same
destination from two BGP4+ neighbors, the switch prefers the route
from the neighbor with the larger weight.
BigIron RX# show ipv6 bgp routes
Total number of BGP Routes: 2
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST C:CONFED_EBGP D:DAMPED
E:EBGP H:HISTORY I:IBGP L:LOCAL M:MULTIPATH S:SUPPRESSED
Prefix Next Hop Metric LocPrf Weight Status
1 2002::/16 :: 1 100 32768 BL
AS_PATH:
2 2002:1234::/32 :: 1 100 32768 BL
AS_PATH: