Brocade BigIron RX Series Configuration Guide - Manual (Page 994)

916 BigIron RX Series Configuration Guide
53-1002484-04
Displaying BGP4 information
27
For information about the fields in this display, refer to Table 141 on page 921. The fields in this
display also appear in the show ip bgp display.
Displaying the adj-RIB-out for a neighbor
To display the device’s current BGP4 Routing Information Base (Adj-RIB-Out) for a specific neighbor
and a specific destination network, enter a command such as the following at any level of the CLI.
The Adj-RIB-Out contains the routes that the device either has most recently sent to the neighbor or
is about to send to the neighbor.
Syntax: show ip bgp neighbor <ip-addr> rib-out-routes [<ip-addr>/<prefix>]
For information about the fields in this display,refer to Table 141 on page 921. The fields in this
display also appear in the show ip bgp display.
Displaying peer group information
You can display configuration information for peer groups.
To display peer-group information, enter a command such as the following at the Privileged EXEC
level of the CLI.
Syntax: show ip bgp peer-group [<peer-group-name>]
Only the parameters that have values different from their defaults are listed.
Displaying summary route information
To display summary statistics for all the routes in the device’s BGP4 route table, enter a command
such as the following at any level of the CLI.
BigIron RX(config-bgp)# show ip bgp neighbor 192.168.4.211 rib-out-routes
192.168.1.0/24
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST I:IBGP L:LOCAL
Prefix Next Hop Metric LocPrf Weight Status
1 200.1.1.0/24 0.0.0.0 0 101 32768 BL
BigIron RX# show ip bgp peer-group pg1
1 BGP peer-group is pg
Description: peer group abc
SendCommunity: yes
NextHopSelf: yes
DefaultOriginate: yes
Members:
IP Address: 192.168.10.10, AS: 65111