Brocade BigIron RX Series Configuration Guide - Manual (Page 627)

BigIron RX Series Configuration Guide 549
53-1002484-04
Configuring MCT
20
The <name> variable specifies the name of the cluster.
The <id> variable specifies the cluster ID.
The <peer-ip> variable specifies the IP address of the peer.
Clearing the MCT cluster information
To clear the MCT cluster information, enter a command such as the following.
BigIron RX# clear cluster abc peer 10.10.10.1
Syntax: clear cluster [<name> | <id>] peer <peer-ip>
The <name> variable specifies the name of the cluster.
The <id> variable specifies the cluster ID.
The <peer-ip> variable specifies the IP address of the peer.
MCT configuration examples
The following examples display the module provisioning information from a configuration file.
Single-level MCT example
For single-level MCT topology diagram, refer to Figure 93 .
TOR-A
lag "1" dynamic id 1
ports ethernet 1/1 to 1/2
primary-port 1/1
deploy
port-name "ICL-to-TOR-B:1/1" ethernet 1/1
port-name "ICL-to-TOR-B:1/2" ethernet 1/2
!
lag "2" dynamic id 2
ports ethernet 1/3 to 1/4
primary-port 1/3
deploy
port-name "lag-client-1:1/1" ethernet 1/3
port-name "lag-client-1:1/2" ethernet 1/4
!
lag "3" dynamic id 3
ports ethernet 1/5
primary-port 1/5
deploy
port-name "lag-client-2:1/1" ethernet 1/5
!
no route-only
!
vlan 1 name DEFAULT-VLAN
no untagged ethe 1/1 to 1/2
!
vlan 2 name client-VLAN
untagged ethe 1/3 to 1/7
tagged ethe 1/1 to 1/2
!