Brocade BigIron RX Series Configuration Guide - Manual (Page 1146)

1068 BigIron RX Series Configuration Guide
53-1002484-04
Displaying 802.1x information
34
Clearing 802.1x statistics
You can clear the 802.1x statistics counters on all interfaces at once, on individual interfaces, or
on a range of interfaces.
For example, to clear the 802.1x statistics counters on all interfaces on the device, enter the
following command.
BigIron RX# clear dot1x statistics all
Syntax: clear dot1x statistics all
To clear the 802.1x statistics counters on interface e 3/11, enter the following command.
BigIron RX# clear dot1x statistics e 3/11
Syntax: clear dot1x statistics [mac-address | ethernet <slot>/<portnum>]
Displaying dynamically assigned VLAN information
The show interface command displays the VLAN to which an 802.1x-enabled port has been
dynamically assigned, as well as the port from which it was moved (that is, the port’s default VLAN).
The following is an example of the show interface command indicating the port’s dynamically
assigned VLAN. Information about the dynamically assigned VLAN is shown in bold type.
RX EAPOL Total The total number of EAPOL frames received on the port.
RX EAP Resp/Id The number of EAP-Response/Identity frames received on the port
RX EAP Resp other than Resp/Id The total number of EAPOL-Response frames received on the port that
were not EAP-Response/Identity frames.
RX EAP Length Error The number of EAPOL frames received on the port that have an invalid
packet body length.
Last EAPOL Version The version number of the last EAPOL frame received on the port.
Last EAPOL Source The source MAC address in the last EAPOL frame received on the port.
TX EAPOL Total The total number of EAPOL frames transmitted on the port.
TX EAP Req/Id The number of EAP-Request/Identity frames transmitted on the port.
TX EAP Req other than Req/Id The number of EAP-Request frames transmitted on the port that were
not EAP-Request/Identity frames.
Num sessions Total number of dot1x sessions, which include authenticated, restricted,
denied and sessions in the initial state.
Num Restricted Sessions Number of current 802.1x sessions that failed authentication. The user
configuration was moved into a restricted VLAN.
Num Authorized Sessions Number of current 802.1x authenticated sessions that are authorized.
TABLE 174 Output from the show dot1x statistics command (Continued)
This field... Displays...