Brocade BigIron RX Series Configuration Guide - Manual (Page 86)

8 BigIron RX Series Configuration Guide
53-1002484-04
Accessing the CLI
1
NOTE
The CLI prompt at the interface level includes the port speed. The speed is one of the following.
BigIron RX(config-if–e100-5/1)# – The interface is a 10/100 port.
BigIron RX(config-if–e1000-5/1)# – The interface is a Gigabit port.
NOTE
For simplicity, the port speeds sometimes are not shown in example Interface level prompts in this
manual.
Navigating among command levels
To reach other CLI command levels, you need to enter certain commands. At each level there is a
launch command that allows you to move either up or down to the next level.
CLI command structure
Many CLI commands may require textual or numeral input as part of the command.
Required or optional fields
These fields are either required or optional depending on how the information is bracketed. For
clarity, a few CLI command examples are explained below.
Syntax: [no] deny redistribute <value> all | bgp | rip | static address p-addr> <ip-mask>
[match-metric <value> | set-metric <value>]
When an item is bracketed with “< >” symbols, the information requested is a variable and
required.
When an item is not enclosed by “< >” or “[ ]” symbols, the item is a required keyword.
When an item is bracketed with “[ ]” symbols, the information requested is optional.
BigIron RX>User Level EXEC Command
BigIron RX#Privileged Level EXEC Command
BigIron RX(config)#Global Level CONFIG Command
BigIron RX(config-if-e10000-5/1)#Interface Level CONFIG Command
BigIron RX(config-lbif-1)#Loopback Interface CONFIG Command
BigIron RX(config-ve-1)#Virtual Interface CONFIG Command
BigIron RX(config-trunk-4/1-4/8)#Trunk group CONFIG Command
BigIron RX(config-if-e10000-tunnel)#IP Tunnel Level CONFIG Command
BigIron RX(config-bgp-router)#BGP Level CONFIG Command
BigIron RX(config-dvmrp-router)#DVMRP Level CONFIG Command
BigIron RX(config-ospf-router)#OSPF Level CONFIG Command
BigIron RX(config-isis-router)#IS-IS Level CONFIG Command
BigIron RX(config-pim-router)#PIM Level CONFIG Command
BigIron RX(config-redundancy)#Redundant Management Module CONFIG Command
BigIron RX(config-rip-router)#RIP Level CONFIG Command
BigIron RX(config-port-80)#Application Port CONFIG Command
BigIron RX(config-bgp-routemap Map_Name)#Route Map Level CONFIG Command
BigIron RX(config-vlan-1)#VLAN Port-based Level CONFIG Command
BigIron RX(config-vlan-atalk-proto)#VLAN Protocol Level CONFIG Command