Assigning ospfv3 areas – Brocade BigIron RX Series Configuration Guide User Manual
Page 1381
BigIron RX Series Configuration Guide
1303
53-1002484-04
Configuring OSPFv3
49
•
Enable the forwarding of IPv6 traffic on the Brocade device using the ipv6 unicast-routing
command.
•
Enable IPv6 on each interface over which you plan to enable OSPFv3. You enable IPv6 on an
interface by configuring an IPv6 address or explicitly enabling IPv6 on that interface.
For more information about performing these configuration tasks, refer to
By default, OSPFv3 is disabled. To enable OSPFv3, you must enable it globally.
To enable OSPFv3 globally, enter the following command.
BigIron RX(config-ospf-router)#ipv6 router ospf
BigIron RX(config-ospf6-router)#
After you enter this command, the Brocade device enters the IPv6 OSPF configuration level, where
you can access several commands that allow you to configure OSPFv3.
Syntax: [no] ipv6 router ospf
To disable OSPFv3, enter the no form of this command. If you disable OSPFv3, the Brocade device
removes all the configuration information for the disabled protocol from the running-config.
Moreover, when you save the configuration to the startup-config file after disabling one of these
protocols, all the configuration information for the disabled protocol is removed from the
startup-config file.
The CLI displays a warning message such as the following.
BigIron RX(config-ospf6-router)# no ipv6 router ospf
ipv6 router ospf mode now disabled. All ospf config data will be lost when writing
to flash!
If you have disabled the protocol but have not yet saved the configuration to the startup-config file
and reloaded the software, you can restore the configuration information by re-entering the
command to enable the protocol (for example, ipv6 router ospf). If you have already saved the
configuration to the startup-config file and reloaded the software, the information is gone. If you
are testing an OSPF configuration and are likely to disable and re-enable the protocol, you might
want to make a backup copy of the startup-config file containing the protocol’s configuration
information. This way, if you remove the configuration information by saving the configuration after
disabling the protocol, you can restore the configuration by copying the backup copy of the
startup-config file onto the flash memory.
Assigning OSPFv3 areas
After OSPFv3 is enabled, you can assign OSPFv3 areas. You can assign an IPv4 address or a
number as the area ID for each area. The area ID is representative of all IPv6 addresses (subnets)
on a router interface. Each router interface can support one area.
An area can be normal or a stub:
•
Normal – OSPF routers within a normal area can send and receive External Link State
Advertisements (LSAs).
•
Stub – OSPF routers within a stub area cannot send or receive External LSAs. In addition, OSPF
routers in a stub area must use a default route to the area’s Area Border Router (ABR) or
Autonomous System Boundary Router (ASBR) to send traffic out of the area.