Brocade BigIron RX Series Configuration Guide - Manual (Page 1404)

1326 BigIron RX Series Configuration Guide
53-1002484-04
Displaying OSPFv3 information
49
Displaying OSPFv3 interface information
You can display a summary of information for all OSPFv3 interfaces or detailed information about a
specified OSPFv3 interface.
To display a summary of OSPFv3 interfaces, enter the following command at any CLI level.
Syntax: show ipv6 ospf interface [ethernet <port> | loopback <number> | tunnel <number> | ve
<number>]
The ethernet | loopback | tunnel | ve parameter specifies the interface for which to display
information. If you specify an Ethernet interface, also specify the port number associated with the
interface. If you specify a loopback, tunnel, or VE interface, also specify the number associated
with the interface.
This display shows the following information.
Prefix Options An 8-bit field of capabilities that serve as input to various routing calculations:
•
NU – The prefix is excluded from IPv6 unicast calculations.
•
LA – The prefix is an IPv6 interface address of the advertising router.
•
MC – The prefix is included in IPv6 multicast routing calculations.
•
P – NSSA area prefixes are readvertised at the NSSA area border.
Prefix The IPv6 prefix included in the LSA.
Intra-area prefix LSAs (Type 9) (Iap) fields
Number of Prefix The number of prefixes included in the LSA.
Referenced LS Type,
Referenced LS ID Identifies the router-LSA or network-LSA with which the IPv6 address prefixes are
associated.
Referenced
Advertising Router The address of the neighboring router that advertised the route.
Prefix Options An 8-bit field describing various capabilities associated with the prefix.
Metric The cost of using the advertised prefix.
Prefix The IPv6 prefix included in the LSA.
Number of Prefix The number of prefixes included in the LSA.
TABLE 227 OSPFv3 detailed database information fields (Continued)
This field... Displays...
BigIron RX# show ipv6 ospf interface
Interface OSPF Status State Area
ethe 3/1 up
ethe 3/2 enabled up DR 0
ethe 3/4 disabled down
loopback 2 enabled up Loopback 0
tunnel 1 disabled down
tunnel 2 enabled up P2P 0
tunnel 6 up