Brocade BigIron RX Series Configuration Guide - Manual (Page 1544)

1466 BigIron RX Series Configuration Guide
53-1002484-04
STP
E
STP
SysLog messages
Commands See ...
show spanning-tree [vlan < vlan-id>] | [pvst-mode] |
[ < num>] |
[detail [vlan < vlan-id> [ethernet < slot/port> ] [|
begin < expression> | exclude < expression> |
include < expression>]
“Displaying STP information for an entire device” on
page 334
show spanning-tree detail [vlan < vlan-id> [ethernet
< slot/port>]]
“Displaying detailed STP information for each
interface”
on page 336
show xstp ethernet < slot/port> “Displaying STP information for the specified
Ethernet interface”
on page 339
spanning-tree [ethernet < slot/port>] [forward-delay
< value>] | [hello-time < value>] | [max-age < value>] |
[priority < value>]
“Changing STP bridge parameters” on page 329
spanning-tree ethernet < portnum> path-cost < value> |
priority < value> | disable | enable
“Changing STP port parameters” on page 330
spanning-tree single [ethernet < portnum> path-cost
< value> | priority < value>]
“Enabling SSTP” on page 343
spanning-tree single [forward-delay < value>] [hello-time
< value>] | [maximum-age < time>] | [priority < value>]
“Enabling SSTP” on page 343
spanning-tree “Enabling or disabling STP globally” on page 328
“Enabling or disabling STP on a VLAN” on page 328
“Enabling or disabling STP on a port” on page 328
Commands See ...
clear logging [dynamic-buffer | static-buffer] “Displaying the Syslog configuration” on page 1381
“Clearing log entries” on page 1383
Ip show-portname “Displaying the interface name in Syslog messages”
on page 1388
ip show-service-number-in-log “Syslog messages” on page 1389
logging buffered < level> | < num-entries> “Disabling logging of a message level” on page 1386
“Changing the number of entries the local buffer can
hold”
on page 1387
logging console “Enabling real-time display of Syslog messages” on
page 1380
logging facility < facility-name> “Changing the log facility” on page 1387
logging host < ip-addr> | < server-name> “Specifying a Syslog server” on page 1385
“Specifying an additional Syslog server” on
page 1385
logging on [ < udp-port>] “Disabling or re-enabling Syslog” on page 1385