Brocade BigIron RX Series Configuration Guide - Manual (Page 61)

BigIron RX Series Configuration Guide lxi
53-1002484-04
Increase Global Static ARP
Entries The system max value for ip-static-arp can be
configured to values up to 16,384 beginning with
version 02.4.00 of the BigIron RX Multi-Service
IronWare software. Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring IP”
Section: “Changing the
maximum transmission
unit on an individual
interface”
OSPF ABR Type 3 LSA Filtering The OSPF ABR Type 3 LSA Filtering feature extends
the ability of an ABR that is running the OSPF
protocol to filter type 3 link-state advertisements
(LSAs) that are sent between different OSPF areas.
Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring
OSPF Version 2 (IPv4)”
Section: “OSPF ABR type 3
LSA filtering”
New show OSPF neighbor by
area command This feature allows OSPF to display the OSPF
neighbors existing in a particular area. Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring
OSPF Version 2 (IPv4)”
Section: “Displaying OSPF
neighbor information”
Track IP route time in show
command The show ip route command has been enhanced to
include the elapse time since an IP route was
installed. Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring IP”
Section: “Displaying the IP
route table”
Compare MED for internal BGP
route with empty as-path This new BGP command directs iBGP to take the
MED value into consideration even if the route has
an empty as-path path attribute. Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring
BGP4 (IPv4 and IPv6)”
Section: “Configuring the
device to always compare
MEDs”
OSPF Default Network Route This feature enables the BigIron RX to use default
route (0.0.0.0/0) to a resolve static OSPF route.
Note:This differs from the default behavior in
previous versions of Multi-Service IronWare
software. Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring
OSPF Version 2 (IPv4)”
Section: “Configuring a
default network route”
IPv6 Default Route ECMP This feature allows for load distribution of traffic
among the available IPv6 default route next-hops. Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring
Basic IPv6 Connectivity”
Section: “ECMP load
sharing for IPv6”
IPv6 Tunneling in Hardware Manual configuration of IPv6 to IPv4 tunnels is now
supported in this release. These tunnels will be
installed into the hardware route table and tunnel
encapsulation and decapsulation is done in
hardware. Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring IP”
Section: “IPv6 over IPv4
tunnels in hardware”
TABLE 14 Summary of enhancements in release 02.4.00 (Continued)
Enhancement Description See page