Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 74)

2-2 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
I/O Panel
Telco connectors with 50-pins, on the I/O panel, are used to connect cables from the various Octel
Overture 200/300 line interface cards (LIC), telemarketing cards (TLC), direct access cards (DAC),
and integration cards to the PBX.
RS-232C Connectors
RS-232 connectors are used for terminal communication. J2 is used for RS-232C integration.
Octel Overture 200 Cabinet
Each Octel Overture 200 cabinet is shipped fully assembled. The cabinet specifications are as
follows:
Height: 24.8 inches (63.0 cm)
Width: 13.0 inches (33.0 cm)
Depth: 19.5 inches (49.5 cm)
Weight: 100 pounds (45.4 kg) maximum
Clearances
Front: 22 inches (56 cm)
Rear: 6 inches (15 cm)
Side: 1 inch (2.5 cm)
Top: 1 inch (2.5 cm)
The Octel Overture 200 outer metal enclosure contains two shelves, with slots for various
configurations of disk drives and system cards. Figure 2-1 through Figure 2-4 show various views
and component locations for the Octel Overture 200 message server.
Shelf A
Shelf A contains 10 card slots, with slots A8–A10 reserved for the voice control unit (VCU) in slot
A8, the central processing unit (CPU) in slot A9, and the power supply unit (PSU) in slot A10. The
card slots in shelf A of the Octel Overture 200 cabinet could contain the following.
Slot Number(s) Card Type/Other
A1–A6 LIC, TLC, DAC, or integration cards
A1–A7 Fax card
A5–A7 LAN card
A7 EntryWorks ACP card
A8 VCU
A9 CPU
A10 (PSU, which includes the floppy disk load device
The Octel Overture 200 can be configured with 4-port, 8-port, or 16-port line cards, in any
combination, to a maximum of 64 ports.
Refer to the Configuration volume, Slots Table chapter, for information about configuring the slots.