Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 227)

R
Quick Reference Guide
Octel Overture 200/300
Maintenance Commands
Octel Overture 200/300 Serenade 3.0 PB60014–01
Section
Information
Command Subject
Integration Integration Unit CD x y Takes the integration unit out of service.
x = slot number
y = unit number
CU x y Brings the integration unit into service.
x = slot number
y = unit number
Integration
(continued) Integration Unit ISTAT x y Gives the current status of an integration unit.
x = slot number
y = unit number
Integration Board L INT x y Lists the current state of the integration board, the
diagnostic status, and the status of the links, and
the pegs.
x = slot number
y = unit number.
Incoming Call
Records MON2 Used to monitor incoming call records over the
RS-232C link (port 2). To exit the monitor mode,
press .
Escape
MON2 H Show call record data in hexadecimal values as it is
sent by the PBX.
Message Waiting
Lamps MWL RELITE Send commands to relight each message waiting
lamp that the Octel Overture 200/300 has marked
as ON.
MWL RECALC Examines each mailbox to determine whether its
message waiting lamp should be ON or OFF.
MWOFF x Turns OFF lamp message waiting.
x = mailbox number. The maximum number of
digits is eight. For ALL, enter A .
L RT 1
C RT 1
List round trip time for message waiting.
Clears round trip time for message waiting.