Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 404)

8-34 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name Priority Remedy Source
66. LAN Card
Reported
Hardware Error
(continued)
Problem detected by
the LAN card. Dependent on the DATA-1 values as
described below. 3
05 = SNMP MANAGER HOST NAME CANNOT BE RESOLVED
Possible reasons include:
- Manager host name may be bad.
- Name server IP address may be bad.
- The Octel Overture 200/300 cannot communicate with the name
server.
- Other — error code in DATA-2 and DATA-3 gives more
information.
REMEDY: Correct the SNMP manager host name.
- Correct the name server IP address.
- Configure the SNMP manager IP address.
DATA-2 = 1, 2, or 3. This tells us where the error was logged
from. DATA-3 and DATA-4 together give 16 bits of error
information.
06 = BAD_SUBNET
The subnet mask for self is not configured correctly. .
Most common reason is that the subnet mask has never been
configured. The subnet mask is configured for SELF only, and the
value configured is shown went the
L Loc command is issued.
REMEDY: Get the correct IP address from the LAN administrator
and reconfigure the message server
07 = DUP_IPADDR — IP ADDRESS CONFLICT.
There is another system with the same IP address in the subnetwork
that includes the message server.
REMEDY: Get the correct IP address from the LAN administrator
and configure it in the definition of SELF.
DATA-2 = ERROR DATA
DATA-3 = ERROR DATA
DATA-4 = ERROR DATA
67 Patching Error Dependent on value in
DATA-4. Contact your technical support center. 3
DATA-4 = 01 PARTIAL PATCH DETECTED
02 PATCH AREA ALLOCATION ERROR