Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 400)

8-30 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name Priority Remedy Source
64. LAN Card
Hardware Error
(continued)
Problem detected by
the LAN card. Dependent on the DATA-1 values described
below. 3
DATA-2 values in case of LAN_LOST_COMM:
1 Unable to read card status.
2 Card status is nonoperational.
3 CB timed out at start of read reply.
4 CB timed out during read reply packet.
5 CB time out at start of send request.
6 CB timed out when checked if took request.
7 CB timed out at end of the read reply.
8 CB timed out during write request packet.
9 CB timed out after write request.
1 0 Complement of replies not match.
1 1 Checksum wrong after control bus copy.
03 = REACHED THE MAX. RETRY COUNT WHILE SYNCHRONIZING.
FORCED RESET DONE TO SYNCHRONIZE.
The CPU is unable to communicate with the LAN card.
REMEDY: Same as for DATA-1 = 02.
04 = LAN CONTROL BLOCK REQUEST SIZE MISMATCH
Compatibility problem with the LAN card.
REMEDY: Contact your technical support center.
05 = LAN CONTROL REPLY BLOCK SIZE MISMATCH
Compatibility problem with the LAN card.
REMEDY: Contact your technical support center.
06 = LAN CONTROL BUS TIME OUT DURING READING/WRITING
CONTROL BUS
Problem with the LAN card.
REMEDY: Contact your technical support center.
07 = OEM NCK OF OTHER SYSTEM DOES NOT MATCH OURS
OEM type between systems is incompatible.
REMEDY: Use the LANSTAT command to determine which location
is in the OEM-FAIL state. Check the OEM type of the
current system. Contact your technical support center.