Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 240)

6-10 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
Command Basic Definition
GWLSTAT This command is used as a diagnostic tool to review the current status of the
OctelAccess server link, to determine
- Whether the OctelAccess server is up or down and if it is down, why is it
down
- Last time the OctelAccess server was initialized
- Number of open sessions
- Statistics about the number of sessions, new calls pending and number of
gateways established.
HELP Displays the allowable commands for the password level of operation currently
logged in to.
INSTA INSTALL
Use this command to enter the message-server configuration program, INSTALL.
This program consists of a series of questions that define the Octel Overture
200/300 database. Answers to questions can be selected from a list, a default
value, or created by the installer.
The required INSTALL command must be a minimum of five letters. After you
have completed the initial INSTALL program, you must enter a
maintenance-level password before the INSTALL program begins.
ISTAT x y Gives the current status of an integration unit, where x is the slot number, and y
is the unit number.
L DMAP Provides information regarding each drive in the system, including the logical
and physical state of the disk, the vendor, the physical and logical size of the
disk, and the disk key, for example, non-COD or COD. This command can only
be issued after a connection has been made to the VCU. Beginning with S3.0.
LANG Displays the languages installed. When a language is selected, this command lists
the settings for the language. These settings can be modified; however, some
settings require a special set of prompts. The settings that can be modified are as
follows:
SPECIAL TRANSLATE
When Japanese and Korean language prompts are used, you can modify this
option to specify either Japanese or Korean. This is required, so that various
counting and grammar phrases are spoken correctly.
CLOCK FORMAT
This option is modified to specify whether the message server is configured for
12-hour, or 24-hour clock, or whether the change from a.m. to p.m. occurs at 1:00
for the 12-hour clock mode.