Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 230)

R
Quick Reference Guide
Octel Overture 200/300
Maintenance Commands
Octel Overture 200/300 Serenade 3.0 PB60014–01
Section
Information
Command Subject
Miscellaneous
(continued) Patch Status PAT STAT This command shows the status of all patches
currently applied on the message server, the patch
number, the date the patch was applied and the
target(s).
Restart RESTA Restarts the CPU. All active ports are dropped, and
the modem is dropped. The maintenance level
password must be entered before restart begins.
Restart RESTA 2 Restarts the CPU. Reloads software from the hard
disk. All active ports are dropped, and the modem
is dropped.
Time TIME Displays the current system date and time. Used
only at the @ prompt.
Network Failures L NF Lists Protocol 2 or Protocol 4 failures.
Refer to the Networking volume —
REMOTE
ANALOG NETWORKING chapter for details.
List Drive Map L DMAP S3.0 Provides disk information report on the
physical characteristic of the disk drive.
VCU VCU S3.0 Connects to the VCU. It provides detailed
drive status, drive configuration, message header
information on installed hardware. In addition,
from this command you can enter the
L DMAP
command to get more details.
Write Protect Drive WPDISK S3.0 This command write protects a disk drive to
prevent any new messages from being created on
that drive.