Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 618)

12-54 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
Hard Disk Replace
These procedures provide the steps to replace a hard disk drive on a message server configured with multiple drives.
.
When doing the Hard Disk Replace procedures, make sure that the diskettes being used are for the correct
release level.
Action Octel Overture 200/300 Description and Response
Hard disks may be hot plugged.
Prepare the System
1. Forward ports.
2. Remove the hard disk(s)
to be replaced.
Boot the System
3. Make sure the software diskette
#1 (for the correct release level)
is write-protected.
4. Insert software diskette #1 (for
the correct release level) into
the FD.
5. Adjust the baud rate of the
terminal/teleprinter to 300,
1200, or 9600 baud.
6. Press the Reload button to boot
from floppy diskette.