Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 226)

R
Quick Reference Guide
Octel Overture 200/300
Maintenance Commands
Octel Overture 200/300 Serenade 3.0 PB60014–01
Section
Information
Command Subject
Integration Card TE INT x y Tells the integration card to run its link selftest.
Used only for systems with integration cards.
x = slot number
y = unit number.
LIC TE L 1 Checks tone generation and detection circuitry.
Diagnostics
(continued) TE L 2 Ring-through test. Use only when no traffic on
system.
TE L 4 x Test to see whether loop current is present on a
specific port.
x = port number.
TE L 5 x Tone reflection test on one port.
x = port number.
Network Routes TE NET x y Tests network routes to a network location.
x = network location code (optional);
y = non-zero show digits entered.
System Status TE S Checks voltages and temperatures.
Fax Application
Processor TE X x y z Fax loopback test. Verifies that the fax modems on
the Fax Application Processor can send and receive
fax data and that the TDM bus connection is
correct.
x = slot number
y and z = fax channels
Data Fields BITTST x Converts hardware error data fields into bit sets.
x = hexadecimal number.
Hardware
Errors List Hardware Error
Table L H Lists the Hardware Error Table.
Clear Hardware
Error Table C H Clears the Hardware Error Table.