Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 357)

Call Processing Trace Activities 7A-5
Octel Overture 200/300 Serenade 3.0 PB60014–01
Table 7A-2 EVENT and AUX Activities in Call Process Trace Log (continued)
TYPE
Column
Entry
DESCRIPTION
AUX
Column
Entry
DESCRIPTION
EVENT
Column
Entry
LAN CONNGRANT Connection has been granted.
COS_OVRID COS override occurred.
COURTESY Generic for courtesy up/down. UP/DOWN
LAN CREATE Created msg to receive new message
delivery.
DEBUG Integration debug records .
DEFERRED Message deferred for mailbox.
LAN,
OctelNet DESTMBX Destination mailbox for the message .
.
The SOURCE field contains the
ASCII name for each destination
address sent.
NAMEFAIL Failure status when ASCII name match
fails.
DIGIT_IN Digit received by system.
DIGIT_OUT Digit received by system.
DIR_INT Direct internal call.
DIR_EXT Direct external call.
DISC_FROM Fax channel disconnect from voice port.
ONT_IN,
ONT_OUT END_MSG End of message (DTMF digit #). Sent by
the base to the node at the end of new
message play.
FAX_MSG END_PLAY The playing of the message has ended. The CPT shows result codes for fax transactions in the AUX
column. For fax messages, the AUX column is empty if the
fax was successful. The most common result codes listed
are for the END PLAY event.
01
02
03
04
05
06
07
08
09
Fax protocol error
Default error code
Modem training failure
Remote fax requested a feature not
supported by the Octel Overture 200/300
Not used
Voice bus timeout
Fax protocol error
VCU not ready
Bad-page-retransmit limit reached
0A
0B
0C
0D
0E
0F
Modem connection failure; no response
from on-board modem
Modem connection failure
Other side disconnected
Operator assistance not supported in fax
Fax system ID match
No fax or busy line