Port status – Reliant Octel 200 and Octel 300 Message Servers PB6001401 User Manual
Page 264

6-34
Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0
PB60014–01
When any of these changes are made, the Octel Overture 200/300 presents the following message when
exiting from the UPDATE program.
WARNING: FOR CHANGES TO TAKE EFFECT INTEGRATION MUST BE RESTARTED
To execute the command
UPDATE INTEGRATION
, at the @ prompt, type
UPINTG
Enter
The Octel Overture 200/300 then prompts the following:
RESTART INTEGRATION . . . ARE YOU SURE YOU WANT TO DO THIS?
This command restarts the integration cards and, therefore, disrupts call processing for approximately 1
or 2 minutes.
Port Status
The command
PORT STATUS
displays the current state of the installed ports. At the @ prompt, type
PS
Enter
The message server responds with the current state of each installed port.
CH 1 CH 2 CH 3 CH 4 CH 5 CH 6 CH 7 CH 8
LSN IDL LSN NEW MOD IDL IDL IDL
CH 9 CH 10 CH 11 CH 12 CH 13 CH 14 CH 15 CH 16
IDL IDL IDL IDL IDL IDL NMS IDL
CH 17 CH 18 CH 19 CH 20 CH 21 CH 22 CH 23 CH 24
ERR ERR ERR ERR ERR ERR ERR ERR
CH 25 CH 26 CH 27 CH 28 CH 29 CH 30 CH 31 CH 32
FX.IDL FX.RCV FX.SND FX.IDL FX.IDL FX.IDL FX.IDL FX.CDN
The port states are shown under each port channel (CH 1, etc.) and the ports might be in any of the states
listed in Table 6-2.