Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 460)

9-28 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
7. Using a flat-bladed screwdriver, tighten the two captive screws that are attached to the front flange of
the drive assembly.
8. Follow the procedure in the Procedures chapter, Hard-Disk Restore/Add/Replace section, in this
volume, to restore the message server to correct configuration.
9. Test the message server for correct operation.
Octel Overture 300 Floppy-Disk-Drive Replacement
In the event of damage or a malfunction, an Octel Overture 300 floppy-disk drive might need to be
replaced. Only floppy-disk drives supplied by Octel can be used to replace a drive or to upgrade a message
server. The disk-drive assembly includes all necessary cables. Do not remove or alter any cables on the
drive assembly. Figure 9-18 shows the floppy-disk-drive assembly for the Octel Overture 300.
.
For the Octel Overture 200, the power supply and the floppy drive are part of the power supply
unit. If the floppy-disk drive malfunctions, these subassemblies must be replaced as a unit. Refer
to the Power Supply Unit Replacement section in this chapter to replace an Octel Overture 200
floppy-disk drive.
Figure 9-18 Octel Overture 300 Floppy-Disk-Drive Assembly