Reliant Octel 200 and Octel 300 Message Servers PB6001401 User Manual
Page 53

INSTALL 1-23
Octel Overture 200/300 Serenade 3.0
PB60014–01
10. SCHEDULE TABLE.
– – – SCHEDULE FOR COS 10 – – –
TIME PERIOD 1:
Enter INFORMATION TABLE number to use. (1–255)
Enter empty line when done.
:
Enter applicable WEEKDAYS as: SU,MO,TU,WE,TH,FR,SA,HOL
(Empty line = MO,TU,WE,TH,FR)
:
Enter START time as: HOURS (00–23): MINUTES (00–59)
(Empty line = 00:00)
:
Enter STOP time as: HOURS (00–23): MINUTES (00–59)
(Empty line = 23:59)
:
TIME PERIOD 2:
Enter INFORMATION TABLE number to use. (1–255)
Enter empty line when done.
:
When you are finished entering all time periods for the SCHEDULE Table, press
Enter
at the
colon. The message server prompts for the default INFORMATION Table number.
Enter the DEFAULT INFORMATION TABLE number to use outside the
TIME PERIODS specified for COS 10 . (1–255)
INSTALL COMPLETE.
WAIT... DONE.
SAVE configuration to a DISKETTE? ( Y/N , empty line = N ).
:
WARNING: FOR PROPER OPERATION SYSTEM MUST BE RESTARTED AFTER INSTALL!
DAY MM/DD/YYYY HH:MM:SS SYSTEMNAME ID:XXXXXX S/N:XXXXXX PBX:00
–––––––– SYSTEM INSTALLATION COMPLETED ––––––––
@
Save the configuration on your backup configuration diskette. Leave the diskette in the disk drive.
The Octel Overture 200/300 must be reloaded for to operate correctly. To reload the Octel Overture
200/300, at the @ prompt, enter
RESTA 2
Enter
After the message server has reloaded, it is recommended that you enter the UPDATE program and
use the
LIST
command to review the answers you just entered. You might also need to change some
of the system parameter values. Refer to the Configuration volume, System Parameter Table chapter,
in this volume.
Use the UPDATE program to modify system parameters and to set COS Attributes.