Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 480)

9-48 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
6. Reconnect all harnesses and cables to the backplane.
7. Fasten the bottom rear panel with four screws, and reconnect the cables as they were.
8. Verify that the power supply unit is OFF . Attach the power cord.
9. Tighten the fasteners on the front of each disk-drive assembly.
10. Test the message server for correct operation by following the procedures in the Installation chapter
in this volume. Verify that the fans are spinning.
Octel Overture 300 Load Resistor Assembly Replacement
If the load-resistor assembly malfunctions, it must be replaced with a new one. Do not attempt to replace
or alter the load-resistor components or wire harness.
Figure 9-28 Cutaway View of the Load-Resistor Assembly
Shelf B
Backplane
LoadĆ
Resistor
Assembly
FanĆ
Assembly
Connector