Reliant Octel 200 and Octel 300 Message Servers PB6001401 User Manual
Page 396
8-26
Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0
PB60014–01
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name
Priority
Remedy
Source
42. Configuration
Error (continued)
Error detected in the
configuration tables
Check the configuration tables.
1
1D =
REMOTE SYSTEM
(NOT OVERTURE 200/300)
CONFIGURED TO
SUPPORT TURNAROUND
DATA-2 =
LOCATION NUMBER OF REMOTE CABINET IN THE
LOCATION TABLE OF THE LOCAL CABINET
SOURCE:
The remote cabinet (not an Octel Overture 200/300) is
configured to support turnaround. The remote cabinet is
an Octel Overture 250/350 or Octel Overture PC, and in
its node profile,
NODE RESPONSE ALLOWED
has been
set to YES for this node.
REMEDY:
Modify the node profile in the remote cabinet and set
NODE RESPONSE ALLOWED
to NO.
1E =
NO QUERY REPLY POSSIBLE. Digital network is not up, do not have
domain feature, or both.
1F =
DOMAIN FEATURE NOT AVAILABLE
DATA-2 =
TYPE OF ERROR
=
1 = QUERIES BEING RECEIVED FROM FIELD
This means that some other system has this cabinet
configured in the domain.
DATA-3 =
REMOTE HOST HANDLE OF THAT CABINET
This can be used to get the IP address of that cabinet by
doing
L HOST
on the LAN card prompt.
DATA-4 =
UNUSED
20 =
OctelNet serial # not configured.
22 =
Sent a prefix the remote side did not recognize during Namesend.
23 =
Other side does not have the Namesend feature.
24 =
Generic Gateway error mailbox has not been configured but is required.
(System Parameter 285)
Go Dial went to initialization prompt.
25 =
Names Directory error during Namesend.
26 =
Multiple domain location configured with same IP address.
27 =
Self numbering plan entry not configured, but matches Alternate self.
28 =
Location for destination network mailbox not found. It is possible that the
network mailbox was in a distribution list and the location was deleted.
DATA-2 =
First 8 digits of the network mailbox.
29 =
No forwarding string defined (system parameter 45) for NPIC.