Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 246)

6-16 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
Command Basic Definition
UPINTG UPDATE INTEGRATION
Use this command to restart the integration cards, which disrupts call processing
for 1 or 2 minutes.
VCU Use this command to connect to the VCU. It provides detailed drive status, drive
configuration, message header information and status on installed hardware. It
also provides error status reported by the VCU such as hard disk drive read-write
errors. In addition, from this command, you can enter the
L DMAP command to
get more details about the disk drive.
WPDISK WRITE PROTECT DISK DRIVE
Use this command to write protect a disk, which prevents any new messages from
being created on that disk. If a message server with one or more drives in a
write-protected condition, a type 34 hardware error is logged.
Refer to DID/E&M Trunk Interface Installation and Maintenance manual, Diagnostic and
Administrative Commands section, for the commands used to communicate with the DID/E&M
Trunk Interface Modules. Refer to the Direct Access Card (DAC) Installation and Maintenance
Manual for information about direct access cards.