Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 387)

System Errors and Traffic Pegs 8-17
Octel Overture 200/300 Serenade 3.0 PB60014–01
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name Priority Remedy Source
34. Power-ON
Diagnostic Error
(continued) Selftest for integration
cards.
TE INT
LI INT
DATA-1 through
DATA-4 designate
errors found.
Replace integration card as indicated by
slot number. 2
DATA-2
Bit 7: Error detected on Link 4
Bit 6: Error detected on Link 3
Bit 5: Error detected on Link 2
Bit 4: Error detected on Link 1
Bit 3: RAM error type 4
Bit 2: RAM error type 3
Bit 1: RAM error type 2
Bit 0: RAM error type 1
DATA-3 = UNDEFINED
DATA-4 = UNDEFINED
34. Power-ON
Diagnostic Error
Selftest for CPU.
DATA-1 through
DATA-4 designate
errors found. Replace CPU. For OCC error, replace
OCC. 3
DATA-1
Bit 7: 5 volts clean out of range
Bit 6: VCC out of range
Bit 5: A to D converter error
Bit 4: PIT1 error
Bit 3: Parity error
Bit 2: DRAM data error
Bit 1: Boot ROM checksum failure
Bit 0: Fatal CPU error
DATA-2
Bit 7: DMA page register error
Bit 6: Unexpected interrupt
Bit 5: PIT2 (8254) timing error
Bit 4: Temperature out of range
Bit 3: -12 volts clean out of range
Bit 2: -5 volts clean out of range
Bit 1: 12 volts motor out of range
Bit 0: 12 volts clean out of range