Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 624)

12-60 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
Action Octel Overture 200/300 Description and Response
Each diskette (software diskette for the correct release level, prompt
diskette, and the backup configuration diskette) must be tested before
completing the remainder of this procedure.
Octel Overture 200/300 prompts
TEST 01 COMPLETE
If any diskette fails the test, a replacement must be obtained before
continuing with this procedure. Refer to the Maintenance Commands
chapter, Floppy Disk Drive Diagnostics section, for a description of this
diagnostic error.
At the @ prompt enter the slot number for the restored drive. The VCU
tests the slot and updates its status record.
Repeat
DSKTST for each drive to be restored.
@DSKTST B3
CURRENT STATUS
Slot Type ID Status
––––––––––––––––––––––––––––––
B3 System1 S1 Active Configured
The following menu is presented:
Test Diskettes
10. Insert a diskette into the floppy
drive.
11. @TE F 1 Enter
12. Repeat steps 10 and 11 for each
diskette.
Choose the Correct Disk Option
13. Insert Diskette #3 (for the
correct release level) into the
FD.
14. @DSKTST Enter
15. @DISKO Enter