beautypg.com

Introduction, Ringer equivalence – Reliant Octel 200 and Octel 300 Message Servers PB6001401 User Manual

Page 5

background image

Octel Overture 200/300 Serenade 3.0

PB60014–01

UNITED KINGDOM REQUIREMENTS

AND

INSTRUCTIONS FOR USE

Introduction

The Octel Overture 300 message server is a 32 to 128 port voice messaging system and the Octel
Overture 200 message server is a 4 to 64 port voice messaging system. When installed at a customer’s
site, the message server attaches to the extension lines of a PABX or directly to the public network via
Direct Exchange Lines.

This document section describes certain operation requirements which must be complied with in the
United Kingdom to allow connection of the message server to a PABX or directly to the public network.

" C A U T I O N A

Failure to comply to the requirements described in this document may invalidate the

compliance of the apparatus, thus prohibiting its connection to the network in the United

Kingdom.

" C A U T I O N A

The approval of this apparatus will be invalidated if it is used with internal software not

formally accepted by BABT. The internal software is not accessible or alterable by the user.

" N O T I C E A

There are no user serviceable parts, or user controls, in the systemenclosure.

" N O T I C E A

Interconnection directly, or by way of other apparatus, of Octel Overture 200 ports or

Octel Overture 300 ports with ports which do not comply with the requirements of BS6301

may produce hazardous conditions on the BT network. Advice should be obtained from

a competent engineer before such a connection is made.

" N O T I C E A

When network addresses (telephone numbers) are manually entered into the system for

autoĆcalling, care should be exercised to ensure that the addresses are correct

" N O T I C E A

This apparatus is not to be used for making calls to the BT emergency service.

Ringer Equivalence

Under normal operating conditions, this apparatus is not meant to form part of a multiple installation; the
port interfaces are the sole termination of the line. Additional apparatus, BT or otherwise, must not be
connected between this equipment and the PABX line or public network.