Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 244)

6-14 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
Command Basic Definition
PRT x PRINT TONE
Use this command to monitor and print DTMF tones entered by the caller, the
DTMF tones sent by the Octel Overture 200/300 port, and the call-progress tones
from the PBX to the terminal. This is a real-time command, and it can be
initiated on only one port at a time. The information is not stored.
In this command, x is the port to monitor. To exit the monitor mode, press
.
Escape
The following lists the types of messages that can be displayed when the PRT
command is initiated:
ANSWER
The Octel Overture 200/300 detected that the called party answered the
telephone.
NO ANSWER
The Octel Overture 200/300 determined that the called party did not answer
within the specified time period.
SLOW BUSY
Reorder tone from the PBX or central office was detected.
FAST BUSY
Reorder tone from the PBX or central office was detected.
VACANT EXT .
Solid dial tone from the PBX or central office was detected.
FLASH
The Octel Overture 200/300 performed a hook switch.
NO DIAL TONE
The Octel Overture 200/300 did not receive a PBX or central office dial tone.
EXPECT DIAL TONE
The Octel Overture 200/300 is configured to expect a PBX or central office dial
tone.
IN—x
x is the incoming digit entered by the caller.
DIAL—x
x is the digits being sent by the Octel Overture 200/300.