Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 237)

Maintenance Commands 6-7
Octel Overture 200/300 Serenade 3.0 PB60014–01
Command Basic Definition
CD x y z COURTESY DOWN
Use the Courtesy Down command with modifiers to remove the following from
service:
- Port or ports CD x y z
- Integration units CD x y
- Fax cards CD x
- LAN cards CD x
For this command, x is the slot number, y is the relative port, or first port in a
range or relative unit number, and z is the port number of last port in range of
ports (optional).
Port or ports – CD x y z
When you use the CD command to specify ports, the Octel Overture 200/300
forwards the ports specified. If no port is specified, the Octel Overture 200/300
tries to forward all ports. If a port is successfully forwarded, it is left in a
forwarded (FWD) state. If a port fails to complete the forward string, it is left in
the no-dial-tone (NDT) state. The Octel Overture 200/300 continues to try to
forward all ports specified until successful or until you press .
.
You can also use the command TE C 1 y z to forward all ports.
Escape
CU x y z COURTESY UP
Use the Courtesy Up command with modifiers to return the following to service:
- Port or ports CU x y z
- Integration units CU x y
- Fax cards CU x
- LAN cards CU x
In this command, x is the slot number, y is the relative port, or first port in a
range or relative unit number, and z is the port number of last port in range of
ports (optional).
Port or ports – CU x y z
When you use the CU command to specify ports, the Octel Overture 200/300 tries
to initialize and cancels forwarding for the ports specified. If no port is specified,
the message server tries to initialize and cancels forwarding for all ports. If a port
successfully initializes and cancels forwarding, it goes to the idle (IDL) state. If a
port fails to complete either the initialization or cancel forward string, it is left in
the no-dial-tone (NDT) state.
.
You can also use the command TE C 2 y z to cancel forwarding of
ports.