Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 195)

Reports 5-13
Octel Overture 200/300 Serenade 3.0 PB60014–01
The exact minutes of storage may vary due to factors including
- The disk itself.
- Manufacturer of the disk.
- Accumulated bad sectors on the disk.
- Single or dual-drive system. For message servers with more than two
drives of different sizes, Hot Standby may consume additional space
on the smaller of two drives, resulting in a loss of capacity for the rated
hours of storage. Refer to the Feature Description volume, Hard Disk
Redundancy chapter, for information about Hot Standby.
Digital Network Performance Report
The Digital Network Performance Report tracks the performance of the LAN card on a message server. It
provides a measure of the messaging traffic across the digital network and the allocation of the LAN
channel resources for the messaging traffic across the digital network. It is accessed as an extension of
the System Performance Report.
To access the Digital Network Performance Report, at the @ prompt, enter
L R Enter
The LIST REPORT menu appears. At the bottom of the menu, enter 1 D , as in the following.
SELECT REPORT TO BE LISTED. (1 – 10, EMPTY LINE = EXIT)
:1 D
The Digital Network Performance Report can also be accessed by using the command L R 1 D .
.
If only 1 is entered for the System Performance report, the report does not include any digital
networking information. The digital networking System Performance report is printed only when
1
D is entered.
All information shown on this report is computed from values pegged in the Traffic Peg Count Table. All
peg table values max out at 65535. When a field has reached its maximum, the entry is displayed as ***,
with a note at the end of the report:
NOTE: *** = Arithmetic Overflow
If fields are overflowing, it is an indication that the report should be listed and cleared at more frequent
intervals, based on the traffic on the digital network.
An example of a Digital Network Performance Report is shown below.